Forum FlexPro – Discuss your topic!

How can I reduce the size of the diagram borders after switching off the legend?

Accueil > Community > General > How can I reduce the size of the diagram borders after switching off the legend?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 29, 2004 at 9:12 pm #12684
    Richard WeisangRichard Weisang
    Keymaster

    We have noticed that if you add a legend to a graph, then remove it, the graph doesn’t return to is previous “non-legend” side and shape. How do we return these to their original size and shape?

    April 29, 2004 at 9:25 pm #8347
    Richard WeisangRichard Weisang
    Keymaster

    We have noticed that if you add a legend to a graph, then remove it, the graph doesn’t return to is previous “non-legend” side and shape. How do we return these to their original size and shape?

    April 29, 2004 at 9:25 pm #9118
    Bernhard KantzBernhard Kantz
    Participant

    The size of the border is auto-adjusted only if some text or graphics reaches out of the view. Therefore, if you would like to make your borders smaller, you have to do this manually. Click on the frame of the graph to select it and then drag the borders to the desired positions through one of the four selection handles or double-click the graph (not the curve) to open its property sheet. Then open the Size tab and set the margins to the desired values.

    support@weisang.com

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.