Forum FlexPro – Discuss your topic!

automatic zoom in other diagram

Accueil > Community > General > automatic zoom in other diagram

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 26, 2008 at 4:10 am #12604
    Dermot CraddenDermot Cradden
    Participant

    I have tried to setup a worksheet to allow for “zoom in other diagram” following the instructions in the helpfile “Automatic Zooming of Segments” but when i move the cursors in the diagram BOTH windows zoom to their highest zoom and i can’t seem to get out of it other than resetting to “show curve in full width”

    June 26, 2008 at 4:10 am #8267
    Dermot CraddenDermot Cradden
    Participant

    I have tried to setup a worksheet to allow for “zoom in other diagram” following the instructions in the helpfile “Automatic Zooming of Segments” but when i move the cursors in the diagram BOTH windows zoom to their highest zoom and i can’t seem to get out of it other than resetting to “show curve in full width”

    June 26, 2008 at 11:44 pm #8973
    Bernhard KantzBernhard Kantz
    Participant

    The description in the FlexPro help is correct.

    Please make sure that you’ve dragged a data set onto the pane. It doesn’t work if you drag a diagram onto both panes!

    support@weisang.com

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.