FlexPro Forum – Discuss Your Topic!

FP8 – Export a diagram to PNG or JPEG file

Home > Community > General > FP8 – Export a diagram to PNG or JPEG file

  • This topic has 2 replies, 2 voices, and was last updated 15 years ago by Anonymous.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 14, 2009 at 1:50 am #12575
    Anonymous
    Inactive

    Hello,

    I’ve set the resoution to 300 DPI when exporting a diagram to a PNG file (or to a JPEG file).
    When I show the file’s properties, the resolution seams to be 96 pixels/inch in both horizontal and vertical directions, and not 300 pixels/inch.

    Also when I import the image in Word document, the image hasn’t the same size in cm than in FlexPro.

    What am I doing wrong ?

    Thanks.

    November 14, 2009 at 1:50 am #8238
    Anonymous
    Inactive

    Hello,

    I’ve set the resoution to 300 DPI when exporting a diagram to a PNG file (or to a JPEG file).
    When I show the file’s properties, the resolution seams to be 96 pixels/inch in both horizontal and vertical directions, and not 300 pixels/inch.

    Also when I import the image in Word document, the image hasn’t the same size in cm than in FlexPro.

    What am I doing wrong ?

    Thanks.

    November 16, 2009 at 9:11 pm #8926
    Bernhard KantzBernhard Kantz
    Participant

    Hello,

    the reason why this happens is that the FlexPro export does not write the image resolution into the file. Only the (correct) size in pixels is written. Most clients assume a default resolution of 92 DPI (screen resolution) in this case which is not what you expect if you exported with a different resolution.

    We already fixed that issue and will release it with the next maintenance update of FlexPro.

    Weisang Support

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.