You can use the commands Cursor Tools/Cursors[Event] > Previous and Cursor[Event] > Next to move the active cursor from peak value to peak value or from marker to marker. On the Cursors tab of the diagram's Properties dialog box you can specify whether you want to go to local maxima, local minima, minima and maxima or markers.

Here you can also enter a hysteresis, which determines what should or should not be recognized as a peak value. If some are skipped when navigating the peak values, you need to decrease the hysteresis. If small waves or noise in the course of the signal are recognized as peak values, then you need to increase the hysteresis.

See Also

Analyzing Data with Cursors

Navigating to a Specific Point in a Diagram