FlexPro Forum – Discuss Your Topic!

Diagramm problems on multi monitor system

Home > Community > General > Diagramm problems on multi monitor system

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 26, 2015 at 7:40 am #12872
    Michael KaufmannMichael Kaufmann
    Participant

    Hello,

    I use FlexPro on a computer with 3 displays.
    After suspending the computer over the night FlexPro is minimized to one monitor like all other windows as well.

    The problem is that the border of the opened diagrams are always reduced to zero on the left and right. So I have to open the properties of each diagram and set a value a bit above zero. After that the borders are corrected automatically by FlexPro. The command to set the borders automatically is always set.

    BTW: Where can I find the changelog to the different versions of FlexPro.

    Regerads

    Michael

    February 26, 2015 at 7:40 am #8532
    Michael KaufmannMichael Kaufmann
    Participant

    Hello,

    I use FlexPro on a computer with 3 displays.
    After suspending the computer over the night FlexPro is minimized to one monitor like all other windows as well.

    The problem is that the border of the opened diagrams are always reduced to zero on the left and right. So I have to open the properties of each diagram and set a value a bit above zero. After that the borders are corrected automatically by FlexPro. The command to set the borders automatically is always set.

    BTW: Where can I find the changelog to the different versions of FlexPro.

    Regerads

    Michael

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.