FlexPro Forum – Discuss Your Topic!

How to delete empty legend frames in diagrams

Home > Community > General > How to delete empty legend frames in diagrams

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 25, 2014 at 10:07 am #12868
    Pavel KloucekPavel Kloucek
    Member

    In FlexPro9 is the new behaviour of legend frame in diagram. There is one frame for each axis now (older versions had only one legend frame for diagram). Is it possible to delete or switch off some of these frames? I have some of them empty, but frame is still here (I can’t switch frame lines).

    November 25, 2014 at 10:07 am #8528
    Pavel KloucekPavel Kloucek
    Member

    In FlexPro9 is the new behaviour of legend frame in diagram. There is one frame for each axis now (older versions had only one legend frame for diagram). Is it possible to delete or switch off some of these frames? I have some of them empty, but frame is still here (I can’t switch frame lines).

    November 26, 2014 at 11:02 am #9373
    Bernhard KantzBernhard Kantz
    Participant

    When using stacked Y Axes the legend is split according to the assignment of the curves to the different axes. It is not possible to individually switch off a subset of the partial legends. One can disable the frames around each part by setting the border color to ‘No Line’. We will change the behavior of empty boxes; in the future no frame will be drawn in this case.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.